Uncoiler for Upper and Lower & Flexible facing material

Uncoiler is no drive type, and is installed two each at the upper part and the lower part separately.

Main feature：
1. Uncoiler is no drive type, and is installed two each at the upper part and the lower part separately.
2. It is very difficult for the flexible facing such as paper, mineral shear non woven, aluminum foil differently on steel plate to entry into a double belt conveyor when it is untied from uncoiler.So, auto tension control device should be installed to uncoiler.
3. The lower & upper uncoiler should be installed at the bottom.
4. It is better to installing the uncoiler close to the inlet for pouring urethane as close as possible.
5. Type : Non drive and pneumatic expansion shaft type which are installed auto centering device and tension device.
6. Quantity：Total 2 sets
-  Upper parts：1 set
-  Lower parts：1 set
7. Max width of uncoiler：Max. 1,400mm
8. Width adjustable by manual：210~1,220mm (by handle)
9. Dimension :  Inner dia. 150mm x out dia. 900mm
- Consist of：Pneumatic expansion shaft
                      Pneumatic Power disk brake
                      Auto Tension device
10. Max. weight of material：1,000kg
11. Max. speed：8m/min
Flexible facing：

Facing materials	Soda kraft paper, Aluminum foil,  mineral shear non oven, etc.
Panel thickness	20~50mm
Panel width	1,200mm