Cuting and trimming recycle device

The cutting and trimming recovery device uses the up and down action of the hydraulic cylinder to make the shearing knife transversely cut the colored steel plate, and uses the linear guide to track the cutting.

Main feature：
1. Lateral tracking cutting uses the up and down movement of the hydraulic cylinder to make the shearing knife transversely cut the colored steel plate, and uses the linear guide to track and cut.
2. Longitudinal shearing action uses gears to cut longitudinally by rotating the shearing blade on the roller shaft up and down. The longitudinal shearing machine is to cut from the side when the steel plate with too wide width is used. Including the running device of the shearing blade and the scrap recycling device after shearing. Can satisfy different customers with a small amount of inventory.
3. The feature of this cutting machine is that it adopts a special design. Through the linear guide and the adjustment screw on the side, the entire cutting assembly can be quickly moved to change different cutting widths. The blade gap does not need to be adjusted, and the efficiency is the same as that of conventional moving disc blades. several times.
4. The simple edge trimming function is mainly used for slitting a part of the redundant sheet to ensure the required width of the sandwich panel. This device adopts frequency conversion control, and the speed is synchronized with the whole line; the waste side winding device is installed on both sides to collect the scrap after slitting.
Technical parameter：

Parameter	Unit	Remark
Maximum cutting width	mm	1280
Maximum sheet thickness	mm	0.4-0.8